top of page

Black Specks in Your Water on Daniel Island? Carbon Fines, Worn Rubber Parts, and What They Mean

Christian Devlin
4 days ago
3 min read

Every so often a neighbor sends me a photo of tiny black specks in the bottom of a glass, the toilet bowl, or the dog's water dish, and asks if something is wrong with the water. Usually the water itself is fine. The specks are coming from something in the house, and where they show up tells you a lot about what that is.

I'm Christian with Avery & Sons Plumbing + Tankless. Here's how I narrow down black specks in a Daniel Island or East Cooper home, and what to do about each cause.

Start with where you see them

  • Right after a new filter went in. If the specks showed up after you installed or changed a carbon filter, they're most likely carbon fines, loose dust from the new cartridge.

  • At one faucet or one toilet only. That points to a part at that fixture, like a supply line, a cartridge seal, or the toilet flapper, rather than the whole house.

  • Only on the hot side. If cold water is clean and hot water has specks, look at the water heater and anything between it and the faucet.

  • Everywhere, hot and cold. That's less common and is worth a closer look at the main line, a whole-house filter, or the water coming in from the street.

Carbon fines from a new filter

Activated carbon is made of tiny granules, and a brand-new cartridge often releases some black dust at first. It isn't harmful, but you don't want it in your glass. Most manufacturers say to flush a new carbon cartridge for a few minutes before using the water. If you skipped that step, run the cold tap for several minutes and the specks usually clear up. If they keep coming long after the filter is broken in, the cartridge may be damaged or the wrong size for the housing.

Under-sink and reverse osmosis systems also have carbon stages, so a fresh set of filters can do the same thing. Here's how often to change water filters so you're not surprised by it.

Worn rubber parts

Charleston Water System, which serves Daniel Island, uses chloramine to keep water safe in the pipes. Chloramine is tougher on some rubber than plain chlorine is, so over the years rubber parts can soften and shed little black bits. If you rub a speck between your fingers and it smears like soft rubber or leaves a black mark, that's a strong clue.

  • Toilet flappers and fill valve seals. Black specks in one toilet bowl, sometimes with a toilet that runs, often mean a worn flapper. Our post on toilet rings and running toilets covers what else wears out in the tank.

  • Rubber supply lines. Older rubber hoses to faucets, toilets, the washer, or the ice maker can break down from the inside. Braided stainless lines with a better liner are a cheap upgrade, and a worn hose is a leak waiting to happen.

  • Faucet cartridges and washers. If specks come from one faucet only, the seals inside that faucet may be breaking down.

We explained more about chloramine in why some carbon filters miss it.

Specks only in hot water

If the cold side is clean, the water heater is the next place to look. Sediment and bits of worn parts can collect in a tank and come out with the hot water, especially after the heater has been sitting a while or after the water was shut off. A flush often helps. If you have a tankless unit, a clogged inlet screen can also trap and release debris. See why scale shortens tankless life for more on keeping one clean.

Specks everywhere

If specks show up at every faucet, hot and cold, and you haven't changed a filter recently, check a whole-house filter first. A cartridge that is torn or overdue can let debris through. Work on the city water lines, like main repairs or hydrant flushing, can also stir up sediment for a short time. If the water was also discolored and it doesn't clear after running the cold tap, call your water provider and let us know too.

When to call us

  • Specks that keep coming back after you've flushed the lines and a new filter is broken in.

  • Specks along with a leak, a running toilet, or low pressure at one fixture.

  • Rubber supply lines in the house that are more than a few years old.

  • Specks only in hot water that a flush didn't fix.

Easy next step

Avery & Sons Plumbing + Tankless tracks down black specks, replaces worn supply lines, flappers, and faucet cartridges, and installs and services whole-house and under-sink filters across Charleston, Daniel Island, Mount Pleasant, East Cooper, and nearby towns. Call (843) 305-5555 or visit averysplumbing.com.

Neighbors, black specks are usually a worn part or a new filter that needs flushing, not a problem with the city's water. Finding the source is usually a quick fix.

 
 
 

Recent Posts

See All

Comments


Avery & Sons Plumbing + Tankless logo with smiling plumber

460 Seven Farms Drive, Suite 300

Daniel Island, SC 29492

©2022 by Avery & Sons - Plumbing, Tankless, Gas, and Drain.

bottom of page
Text Us
Call Now