top of page

5 Micron or 20 Micron? What the Numbers on Sediment Filter Cartridges Mean for Daniel Island Homes

Christian Devlin
1 day ago
3 min read

When a neighbor on Daniel Island goes to buy a replacement cartridge for their whole-house filter, they usually hit a wall of numbers: 50 micron, 20 micron, 5 micron, 1 micron. The boxes all look alike, and it's easy to assume the smallest number is the best one. Sometimes it is. A lot of the time it just means a filter that clogs in a few weeks and a shower with half the pressure it used to have.

I'm Christian with Avery & Sons Plumbing + Tankless. Here's how to read those numbers and pick the right one.

What a micron rating actually means

A micron is one millionth of a meter. A human hair is somewhere around 50 to 70 microns wide, so even a 50 micron filter is catching pretty fine stuff. The rating tells you roughly the smallest particle size the cartridge is built to trap. Lower number, finer filter.

One catch: most sediment cartridges are rated nominal, not absolute. A nominal rating means the filter catches a good share of particles at that size, not every single one. An absolute rating is a tighter promise. If a box doesn't say which, assume nominal.

Finer isn't automatically better

The finer the filter, the more it catches, and the faster it fills up. As it loads with sediment, water has a harder time getting through, and you feel that as low pressure at the fixtures. Put a very fine cartridge alone on a whole-house line and you may find yourself changing it far more often than you planned. We covered that pressure problem in our low water pressure and whole-house filter post.

Common ratings and where they fit

  • 50 micron and up. Coarse protection. Catches sand, grit, and bits of debris that get stirred up after a water main repair or hydrant flushing. Often used as a first stage or a spin-down screen.

  • 20 to 30 micron. A good all-around whole-house choice on city water. Catches most visible sediment without choking the flow.

  • 5 micron. Finer polishing. Useful as a second stage, or ahead of equipment that doesn't like grit. On its own, it will load up faster.

  • 1 micron and below. Very fine. Usually belongs under the sink, at a drinking water filter or as a prefilter for reverse osmosis, not as the only filter on the whole house.

Staging: coarse first, then fine

The setup that usually works best is two stages: a coarser filter catches the big stuff, then a finer one cleans up what's left. The first stage protects the second, so the fine cartridge lasts much longer. That's also why the order of equipment matters, which we walked through in filter or softener first.

Keep in mind that a sediment filter is not a carbon filter. A 5 micron sediment cartridge does nothing for chlorine taste or smell. If that's your complaint, you need carbon, and the cartridge should list what it's certified to reduce. Our NSF ratings guide explains how to read that part of the box.

Cartridge types: pleated, spun, and string-wound

  • Pleated. Lots of surface area, so they handle flow well. Many can be rinsed and reused a few times, though they won't last forever.

  • Spun (melt-blown). Get denser toward the center, so they trap particles through the whole depth of the cartridge. Inexpensive and common.

  • String-wound. Tough and good at holding a lot of sediment. A solid choice where there's more grit in the water.

How to tell if you picked the wrong one

  • Water pressure drops noticeably within a few weeks of a cartridge change. The filter may be too fine for the job, or it needs a coarser stage in front of it.

  • The cartridge looks clean when you pull it, but you still see grit in aerators. It may be too coarse, or water is getting around a bad O-ring.

  • You see black specks after a change. That's often carbon fines from a new carbon cartridge, not sediment. More in our black specks post.

If the housing itself is leaking or stuck, our guide on changing a whole-house cartridge without a mess walks through it.

Easy next step

Avery & Sons Plumbing + Tankless installs and services whole-house sediment and carbon filters, under-sink filters, reverse osmosis systems, and water softeners across Charleston, Daniel Island, Mount Pleasant, East Cooper, and nearby towns. If you're not sure which cartridge your system needs, or you want a two-stage setup that doesn't kill your water pressure, call (843) 305-5555 or visit averysplumbing.com.

Neighbors, the smallest number on the shelf isn't always the right one. Match the filter to the job, and your water pressure will thank you.

 
 
 

Recent Posts

See All

Comments


Avery & Sons Plumbing + Tankless logo with smiling plumber

460 Seven Farms Drive, Suite 300

Daniel Island, SC 29492

©2022 by Avery & Sons - Plumbing, Tankless, Gas, and Drain.

bottom of page
Text Us
Call Now